HOME DEPOT 22333NKIT-WH 3 Light LED AC Puck Light Kit User Guide
Table of Content
Press the fixture wire , with grooved side to the right down and into the front of the plug . The fixture wire can be cut to the desired length if necessary. This helps to minimize the amount of wire underneath the cabinets. • Directly wire this fixture to a wall switch using Direct Wire junction Box , sold separately. • Use nail-on fasteners to attach the wire to the cabinet.
Working from right to left the red mark on the mounting brackets should face the back of the cabinet. Working from left to right the red mark on the mounting brackets should face the front of the cabinet. Please contact customer service if you have further questions on the lights or dimmers. Please refer to wattage capacity on the dimmer packaging.
Image details
Read all instructions completely before you begin installation. The product is dimmable and can be used with a dimmer switch. Read all instructions carefully before you begin this installation. Pre-pay for multiple images and download on demand.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. The manufacturer warrants this product to be free from defects in materials and workmanship for a period of five years from date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product.
Buy this stock image now…
Change or modification to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
• Connect the LED puck assemblies to each other. Connect the power cord to the first puck light. Make sure the lights are in a single pole with the dimmers, and the total wattage of the lights do not exceed the dimmer wattage capacity. • Install the mounnting cap to the underside of the cabinet by inserting mounting screws into the mounting holes on the mounting cap . Line up the screw holes at the 12 and 6 o’clock position.
Comments
Post a Comment